Readers says In Bootloader

Readers says In Bootloader

If the reader remains stuck with the message In Bootloader, and you've already tried power cycling the reader (unplugging power going to the machine for 2 seconds, then plugging power back in), this indicates some corruption with the flash memory. The board will need to be replaced. Contact your dealer or Laundroworks support.

    • Related Articles

    • Readers are not showing up on the Portal

      Situation You've activated the reader using the Activation card but they are not appearing on the web Portal. Either none of the readers are showing up the inb Machines table or at least the one you're expecting. The Machine table might look like ...

    • Portal says "Timeout - check reader/machine" - Card Reader is Reporting it's offline

      Issue: One or more of the card readers are reporting a "Timeout - check reader/machine" error on the Laundro Portal. You may also see readers showing the error message "Check if machine exists. Remove this row if not.: If all card readers are ...

    • Reader says "Can't Join"

      The reader shows "Joining Netwk" and "Can't Join" when booting. This means that the reader is unable to communicate with the wireless network gateway inside the Value Add Center (in VAC01). NOTE: This is related to the Laundroworks wireless network ...

    • Reader automatically gets Deactivated (says Not Activated)

      If a reader, that was previously activated, suddenly shows Not Activated on the reader's display, it could mean that the reader was able to reset itself back to it's factory default settings. Proceed as follows... 1. Unmount the reader and locate the ...

    • Reader and Value Add Center (VAC) Error Messages

      This article contains tables with common error codes/messages that you may experience; a brief description of the issues; and/or a link to the relevant article(s) that discuss possible solutions for each. Value Add Center Messages (as seen in the VAC ...