Value Add Center
Replacing Asahi-Seiko Card Dispenser
This article covers instructions for replacing the Asahi-Seiko card dispenser with a SyncoTek Card dispenser Parts Needed ASSY-CD-SK-AD1 (Assembled SyncoTek card dispenser) 01-06-65 (Mounting base plate for SyncoTek dispenser) 03-01-77 (KP-210 ...
Replacing Internal USB cable inside Monitor
The article contains instructions for replacing the internal USB cable inside the Touch Monitor. Steps 1. Power down the Value Add Center kiosk 2. Disconnect cables from the back of the Touch Monitor (Power jack, HDMI, and USB) 3. Remove monitor from ...
Replacing Monitor Display Board
The article contains instructions for replacing main display board in the touch screen monitor. Steps 1. Power down the Value Add Center kiosk 2. Disconnect cables from the Touch Monitor (Power jack, HDMI, and USB) 3. Remove monitor from the VAC (you ...
Replacing Touch screen Monitor
Follow the steps below. Especially for rear-access VACs, you need TWO people for this operation - one behind the VAC and one in front, holding the monitor, so that it doesn't fall out once the fasteners are removed. Step 1: Power off the VAC ...
Installing PINpad (Credit card terminal) - US Customers
This article is for customers who receive a PAX A35 PINpad terminal (for new or existing locations) and need to install it into the Value Add Center kiosk. PAX A35 PINpad Installation The following shows the various connections of the PAX A35 PINpad. ...
VAC Control Board Connectivity and Replacement
This article is useful if you are replacing any components inside the Value Add Center (VAC) kiosk. If you're replacing a VAC control board, you may need the Activation card to activate the board (the VAC will display Not Activated in this case) VAC4 ...
Replacing the Card Dispenser's RFID Reader Board
Step 1: Power off the VAC Step 2: Locate the Reader board for the Card Dispenser. If you have a back access door VAC, your reader can be seen behind the card Dispenser stacker as shown below: Step 3: Remove the 5 Pin Connector from the Board: Step 4: ...
Drawings and Dimensions
Attached are the drawings and dimensions To be clear - for the Back-door, Touch VAC (All-In-One), the box that sits inside the wall is 23" x 23".
Activating the PINpad payment terminal (US customers)
This article is for customers who have already finalized their merchant account setup, with the payment processor, and need to activate the PINpad terminal attached to the Value Add Center kiosk. If you have already been processing with the payment ...
Configuring the Verifone P400 (Canada)
Overview For new or replacement PINpads, you will need to configure the IP parameters on the pinpad's configuration menu. These parameters are the same for all PINpads. For new deployments, you will also need to set the Merchant ID and ECR ID ...