Speed-Queen SCxxAC washers (B-micro with A controls)
This installation covers Speed-Queen/Huebsch washers with B-micro with "A" controls. The model number of these machines is SCxxAC or HCxxAC. The reader uses a single pulse control to start the machine.
Parts
- Reader
- Cable harness
- Power supply adapter for the reader
Installation
- Set the machine type and number using the DIP switch on the back of the card reader.
See DIP switch settings page for more info.
Turn machine power OFF! - Remove coin drop
- Start wires
The connection is to the Coin1 input. Splice the White and Green wires from the harness to the White and Red wires from the coin drop (or to wires coming off of J22-2-7 and J22-2-5). - Power
Splice the AC-side of the 12V power adapter to the power terminal block (110V or 220Vac). Connect the DC side of the 12V power supply to the red (+ive) and blue(-ive) wires on the cable harness - Secure the reader to the machine and power up the machine
- Activate the reader using the store's Activation Card:
Vend Prices
The reader sends a single pulse. Configure the washer to start off a single pulse (i.e configure the value of a pulse to equal the cycle cost, or set cycle cost to one quarter). Set the reader vend prices on the LaundroPortal
Related Articles
Alliance: B-micro (SCxxB)
Speed-Queen SCxxB washers (B-micro) This installation covers Speed-Queen/Huebsch washers with B-micro controls. Parts Reader Cable harness Power supply adapter for the reader Installation Before proceeding, you should assign numbers to each of the ...Alliance - Serial Controls (Non-touch controls)
This article covers installation and troubleshooting of readers for Alliance equipment (Speed-Queen, Huebsch) with serial controls, which includes most modern Alliance equipment. The content covers both small-chassis machines and large multi-load ...Alliance: V-computer washers (SCxxVC)
This article covers installation of readers on Alliance washers (Speed-Queen, Huebsch) with the V-computer controls. These typically have model numbers SCxxVCVQU1 Required parts Reader (model CR-11-117-22. The board should be ASSY-02-02-11 (Generic ...Emerald Controls
This article covers installation of readers on Wascomat washers with Emerald controls (like E620 SU655E). The readers use pulse control Required parts Reader (model CR-11-118-04. The board inside the reader must be "Generic Relay") Cable harness 12V ...IPSO: All Belgium-built washers
This installation covers older Belgium-built IPSO washers with micro-20 or sigma control boards. The reader uses a single pulse to start the machine. Only a single vend price is supported. Parts Reader (CR-11-124-03 or CR-11-150B-03). The reader uses ...