Wascomat: Encore/Crossover Washer

Wascomat: Encore/Crossover Washer

This installation covers Wascomat Encore and Crossover washers. The reader uses serial communication to communicate with the machine. Both card-ready and coin models are covered.

Parts

  • Reader
  • Cable harness

Installation

  1. Before proceeding, you should assign numbers to each of the machines in the laundry room/building. It is highly recommended that you place number labels on each washer and dryer machine.

  2. Set the machine type and number using the DIP switch on the MCU circuit board: 



    See DIP switch settings page for more details.

  3. Turn machine power OFF!

  4. Remove the coin drop if present

  5. Connect the signal connector




    For Top-load washers, the cable harness are usually inside the meter case.



  6. Connect the 2-pin power connector

    Both Crossover and Encore washers always have a mating 2-pin mating power connector. It might be buried inside the wiring. For Top-load washers, it can be found in the meter-case (see photo above in Step 5). For Front-load washers, the mating connector typically comes from the white module on the side of the machine, as below:




  7. Proceed to secure the reader to the machine using the nuts

  8. Enable Serial Communication on washer


    Press the service mode switch.
    All LEDs flash. Press the HEAVY SOIL and EXTRA RINSE buttons SIMULTANEOUSLY.
    The display shows "0 00". Press the START button. 0 00 flashes.
    Press the COLD cycle button. The display now flashes "1 00". Press the START button.
    Display stops flashing. Press the service mode switch. The display will now show "-- --", indicating that the controller is in SERIAL COMMUNIOCATION mode, and awaiting commands.

    To switch it back from serial: Locate small “red” reset button behind the left digit in the display. Press and hold down button. 


  9. Activate the card reader using this store's Activation Card:



Pricing

Set the pricing on the reader using the LaundroPortal. Multi-price vends are supported.


    • Related Articles

    • Wascomat: Crossover Dryer

      This installation covers Wascomat Crossover Dryer (Crossover dryers use the same control as ADC Phase 5 dryers). The reader for these dryers use a basic pulse interface to add dry time when the card is presented. Parts Reader Backplate Cable harness ...
    • Wascomat: Encore Dryers

      This installation covers Wascomat Encore Dryers. The reader uses Pulse control. The cable harness and connection is identical to Encore washers. Parts Reader Cable harness Installation Do not mix up readers for washers and readers for dryers. They ...
    • Alliance: Netmaster washer (SCxxN)

      This installation covers Speed-Queen/Huebsch washers with Netmaster controls. The reader uses Pulse control through a designated pulse interface on the machine's control.  (Shown above is a card-ready version with an ESD reader - just for reference) ...
    • Wascomat: Gen5 and Gen6 washers

      This installation note covers the old Gen5 and Gen6 washers. These are non-electronic, high voltage machines. The reader kit comes with a High Voltage Relay to control this timer. The reader is powered by a separate AC-DC power supply adapter ...
    • Wascomat/Electrolux Selecta II dryers

      This article covers installation of readers on Wascomat or Electrolux dryers with Selecta II controls. The readers use pulse control. Required parts Reader (model CR-11-130-04 for stacks, CR-11-230-04 for singles) Cable harness Power supply (in some ...